Spray the mold with release spray. Set it on a flat surface where it will not be disturbed or on a cookie sheet so you can move it to a safe place once you are finished. Wearing gloves, place 2 inches of resin in the plastic cup, measuring up from the bottom of the cup. Mark a line where it is filled to, then pour the resin into a second cup. Fill the first cup to the line with the hardener and pour it into the resin. Mix for 2 minutes with a craft stick, being sure to scrape the sides and bottom. Pour the mixture into a third cup and mix for an additional 2 minutes. Mix in a resin dye, adding it a small amount at a time until you get the desired color. Allow the mixture to sit for 5 minutes to allow the air pockets to dissipate. Pour the resin into the mold, filling until it is level with the top. Allow it to cure for 2 hours without disturbing. Turn the mold upside down and lightly tap to release the bracelet.
by Jewelry » 11 July 2011